The Audient RM1 is a reference measurement microphone made for RoomTune, the monitor correction system built into Audient's iD MK3 audio interfaces. It is for iD MK3 owners who want to measure how their room colours the sound of their studio monitors and correct for it. The RM1 comes with the iD2+ and iD4+, and iD1 and iD2 owners can add it separately.
-
Individually calibrated: every RM1 is measured at the factory and gets its own frequency response profile, so RoomTune removes the mic's influence from each measurement
-
Serial-number setup: entering the mic's serial number loads its personal calibration profile
-
Automatic levels: RoomTune handles phantom power, mic gain, monitor level and latency compensation, with nothing to set by hand
-
MEMS capsule: omnidirectional electret-condenser design covering 20Hz to 20kHz
-
Standard connection: 3-pin XLR output powered by +48V phantom power
In use, the RM1 connects to the interface and RoomTune walks you through a guided measurement in iD Control, which takes under 20 minutes. Because the calibration data for your specific mic is applied to every reading, the resulting correction targets only your monitors and the room rather than the microphone.
The correction itself runs on the interface hardware, uses no computer CPU and is active as soon as the monitors are powered up. On iD2 and larger models, profiles can be stored for two pairs of monitors. The RM1 requires an iD MK3 interface (iD1, iD2, iD2+ or iD4+) for RoomTune.