UltraViolet features full MIDI implementation and 300 presets, allowing you to control it remotely by sending MIDI commands from your controller or DAW via the EXP/MIDI jack or USB-C connection.
Remotely bypass or engage the pedal, automate Speed or other knob adjustments in your DAW or recall unique presets for each song on your setlist — the possibilities with MIDI are limitless.
True/Buffered Bypass
UltraViolet lets you choose between electromechanical relay-switched true bypass for a 100% untouched and unprocessed signal when the pedal is not engaged (which is the default), or our premium buffered bypass, which preserves your signal’s integrity by preventing the high frequency roll-off that can happen due to longer cable runs.
JFET Input
Uncompromised dynamics and feel. Exceptional touch sensitivity and responsiveness. UltraViolet feels just as good as it sounds, thanks to a high-impedance, ultra-low noise and discrete Class A JFET preamp input.
Stereo
Even though it might look like it’s a standard mono effect, there’s no need to make compromises when it comes to signal routing or pedal placement with UltraViolet.
Equipped with a single TRS input and TRS output jack in a dual mono configuration, the pedal keeps to a compact form factor while still giving you the option to use it in stereo.
A dedicated rear panel Input switch allows you to determine the audio routing, selecting between Mono In → Mono Out, Mono In → Stereo Out, or Stereo In → Stereo Out (stereo in and out requires a TRS cable for each jack).
ARM Processor
An evolution in technology led by mobile phones and laptop computers now allows our pedals to perform more simultaneous processes than ever before, and with significantly less power draw.
That means more processing power for every sonic nuance, and less power consumption on your pedal board.
-
High impedance ultra low-noise discrete Class A JFET TRS stereo input.
-
Low impedance TRS stereo output.
-
Expression pedal input allows the connection of a TRS expression pedal, MiniSwitch,
MultiSwitch Plus, or TRS MIDI connection.
-
USB jack for controlling via MIDI from a computer or for performing firmware updates.
Audio Quality
-
Premium JFET analog front end
-
Super low noise, high performance 24-bit 96kHz A/D and D/A converters provide
uncompromising audio quality
-
High Performance 520MHz ARM Superscalar processor
-
32-bit floating point processing
-
20Hz to 20kHz frequency response
-
Typical signal to noise ratio: 116dB
-
Audio Input Impedance: 1M Ohm
-
Audio Output Impedance: 100 Ohm
More
-
Strong and lightweight anodized aluminum chassis
-
Power requirements: maximum 9 volts DC center-negative, with a minimum 250mA of
current. (Adapter sold separately.)
-
Dimensions:
4.5” deep x 1.7” wide x 2.2” tall
11.43 cm deep x 4.32 cm wide x 5.59 cm tall
-
Designed and built in the USA